Samsung CLX-9250ND - Page 431

7. Trouble
s
● Code :
M3-2330
● Error message :
Output tray (face up
)
● Symptom / Cause :
Too much paper in output bin tray (paper out put sect
i
- The bin full sensor actuator or sensor is defective.
● Troubleshooting method :
1. If the face up actuator doesn’t come down or come
d
the side unit. Reassemble the actuator or re
p
lace it.
p
2. Enter the diagnostic mode, and execute the face up
When lifting the bin full actuator, if “without paper” i
s
reconnect the connector.
3. If the photo interrupter is broken away from the sid
e
and reassemble the photo interrupter
and
reassemble
the
photo
interrupter
.
4. Check if the photo interrupter connector, junction c
o
If the connector is unplugged, remove exit unit and
r
5. Replace the Side Joint board.
● Replacement part
- JC92-02233A : SIDE JOINT
Service Manual
CLX-9250/9350 series
7-
9
s
hooting
)
is full. Remove printed media.
i
on)
d
own slowly, remove the black cover on the top of
bin full sensor test.
s
displayed, replace the photo interrupter or
e
unit, remove black cover on the top of the side unit
o
nnector are connected properly.
r
econnect the connector.
SAMSUNG ELECTRONICS
9
1