Samsung CLX-9250ND - Page 430

7. Trouble
s
● Code :
M3-2230
● Error message :
Output tray (face do
w
● Symptom / Cause :
Too much paper in output bin tray (paper out put sect
i
- The bin full sensor actuator or sensor is defective.
● Troubleshooting method :
1. Remove the exit unit from the set. And replace the
f
2. Enter the diagnostic mode, and execute the face do
2.
Enter
the
diagnostic
mode,
and
execute
the
face
do
When lifting the bin full actuator, if “without paper” i
s
reconnect the connector.
3. If the photo interrupter is broken away from the exit
interrupter.
4. Check if the photo interrupter connector, junction c
o
If the connector is unplugged, remove exit unit and
r
5. Check if the regi connector on the engine controller
Reconnect it.
6. Replace the engine controller PBA.
6.
Replace
the
engine
controller
PBA.
● Replacement part
- JC90-00914A : EXIT (CLX-9350ND)
- JC90-00914B : EXIT (CLX-9250ND)
- JC92-02129A : PB
A
-ENGINE
(
CLX-9350ND
)
(
)
- JC92-02239A : PBA-ENGINE (CLX-9250ND)
Service Manual
CLX-9250/9350 series
7-
9
s
hooting
w
n) is full. Remove printed media.
i
on)
f
ace down antistatic brush.
wn bin full sensor test.
wn
bin
full
sensor
test.
s
displayed, replace the photo interrupter or
unit, remove the exit unit and reassemble the photo
o
nnector are connected properly.
r
econnect the connector.
is connected properly.
SAMSUNG ELECTRONICS
9
0