Samsung CLX-9250ND - Page 429

7. Trouble
s
● Code :
M3-1211
M3-1213
M3-1214
M3-1311
M3
-
1313
● Error message :
Paper jam in exit ar
e
M3
1313
M3-1314
M3-1510
● Symptom / Cause :
Paper transport jam (paper output section)
- The paper has not reached the exit sensor or face u
p
output sensor.
● Troubleshooting method :
1. Open the side door. And remove the jammed pape
r
Close the side door. After warm up, if same jam oc
c
2. If the idle roller of the exit unit is damaged or not as
s
3. If there is any obstacles on paper path of the exit u
n
4. Enter the diagnostic mode, and execute the exit se
n
Be the paper at sensor. If
“
Without paper
”
message i
Be
the
paper
at
sensor.
If
Without
paper
message
i
5. Check if the return gate of the exit unit is assemble
d
Reassemble or replace the spring. ( Solenoid sprin
g
6. Reconnect the exit unit wall connector and close th
e
7. If the problem persists, disassemble the exit unit an
d
If any part is damaged, replace it.
A. Check if the gate return is damaged or deformed.
B. Check if the idle roller, holder in the exit unit is da
m
C. Check if the actuator exit sensor is damaged.
D. Check if the photo interrupter is damaged or the c
o
8. Check if the exit connector on engine controller. Re
c
9. Replace the engine controller PBA.
● Replacement part
- JC92-02233A : SIDE JOINT
Service Manual
CLX-9250/9350 series
7-
8
s
hooting
e
a.
p
exit sensor within normal time after passin
g
the
g
r
.
c
urs, check the following.
s
embled, reassemble it properly.
n
it, remove it.
n
sor test.
is displayed, replace the sensor.
is
displayed,
replace
the
sensor.
d
with torsion spring on the rear of set properly.
g
is the same )
e
side door.
d
check the following.
m
aged.
o
nnector is connected properly.
c
onnect it.
SAMSUNG ELECTRONICS
8
9