Samsung FP-T5894W - External Signal Source Selection; Changing Screen Size Options

Press the P.SIZE button on the remote control to
change the picture size.
Press the ~ or " bullon to select the screen format
you want. Press the ENTER button.
Viewing an External Signal Source
Use the remote control to switch between viewing signals
from connected equipment, such as a VCR, OVO, Set-Topl
Cable Box or the TV source (broadcast or cable).
I Setting the Signal Source
The easiest way to set the signal source is to simply press
the SOURCE button on the remote control.
You can also set the source through the menu by following
the instructions below.
O
Press the MENU button.
Press the ~ or " button to select Input, then press
the ENTER button.
• 16:9: Sets the picture to 16:9 wide mode.
• Zoom1 : Magnifies the size of the picture on the
screen,
• Zoom2: Expands the Zoom1 format picture.
• Wide Fit: Enlarges the aspect ratio of the picture to
fit the entire screen.
• 4:3: Sets the picture to 4:3 normal mode.
• Just Scan: Use this function to see the full
image without any cutoff when HOMII
Component (720p/1 080i/1 080p) or
OTV(1 080i) signals are input.
Just Scan
Use this function to see the full
image without any cutoff when
HDMI/Component (720p/1080i!
1080p) or DTV(1080i) signals
are input.
Wide fit
Enlarges the aspect ratio
of the picture to fit the
entire screen.
Z22m1
The screen size when
Wide screen is vertically
enlarged.
RETURN tFO W1DI
@ 0 0
__ D~P'SlZE
lilTS SRS PP
CJ Q.!] CJ -
FAVCH AUTOPROG. ADOmEl --2!-
CJCJCJ~
Z22m1
The screen size when
the Zoom1 screen is
vertically enlarged.
~
Sets the picture to 4:3
normal mode.
~
Sets the picture to 16:9
wide mode.
. CooI1
.. More
Color Tone
..
TV-~
~------J
·AV1--------- -
AV2
S-Vodeo
Component1
Component2
•... , HDMI1
. ·More~_~~~
-'-, -.........---";. Move. G' Enter ,"0 Return
..
J.
- T V .-.-.-. Picture ---:..==
!slZ~ ~~=169-~-=--~
Digital NR : Aulo ~
Active Color : On ~
DNle : On ~
Resel : OK ~
.,'-' -"'~-/:'Mov'-G"Enter :O'ReiU'm
Press the MENU bullon.
Press the ~ or " button to select Picture, then press
the ENTER bullon.
Press the ~ or " button to select Size, then press the
ENTER button.
,. HDMI1 HDMI2, or HDMI3 Input can only be
selected when the external device is turned on
and connected via HOMI
,. You can choose only those external devices
that are connected to the Wireless Home AV
Center
Changing the Screen Size
Press the ENTER button again to select Source
List.
Press the ~ or " bullon to select a signal
source, then press the ENTER button.
Occasionally, you may want to change the size of the image
on your screen. Your TV comes with six screen size options,
each designed to work best with specific types of video input.
Your cable box or satellite receiver may have its own set of
screen sizes as well.
In general you should view the TV in 16:9 mode as much as
possible.
o
English· 13