Samsung FP-T5894W - Page 93

AIr
Start
•
Gable
'-si8ri'
Air + Cable
Start
~-Move
l3' Enter
:) Return
Press the'" or ~ button to select the antenna
connection, then press the ENTER button
• Air "Air" antenna signal.
Cable: "Cable" antenna signal.
Air+Cable: "Air" and "Cable" antenna signals
TV
---~o~--
Select the antennas to memorize
Picture Control
Your TV has three automatic picture settings ("Dynamic",
"Standard", and "Movie") that are preset at the factory, You
can activate either Dynamic, Standard, or Movie by making a
selection from the menu,
Please be aware that the best picture on this TV will be
obtained from High Definition (HD) sources such as Digital
cable or DVD players.
O
Press the MENU button,
Press the & or T button to select Picture, then press
the ENTER button.
Press the & or T button to select digital or analog
channels, then press the ENTER button. You can
select the correct signal source among STD, HRC
and IRC by pressing the & or T button, then press
the ENTER button.
• If you have Digital cable TV, select the signal
source for both Analog and Digital.
• STD, HRC, and IRC identify various types of
cable TV systems. Contact your local cable
company to identify the type of cable system that
exists in your particular area.
At this point the signal source has been selected.
TV _ ----_Picture_--
Mode Dynamic ~
Contrast = 100
Bnghtness = 45
Sharpness = 75
~ Color = 55
lint GSO=RSO
.. More
; Move l3' Enter :) ExIt
PA Press the ENTER button again to select Mode.
TV -~re __ -
Mode DynamIC ~
Contrast = 100
Bnghtness = 45
Sharpness = 75
• Color = 55
linl G50==R50
.. More
; Move l3' Enter :) Return
Press the ENTER button,
Press the & or T button to select Dynamic,
Standard, or Movie, then press the ENTER button,
• Choose Dynamic to increase the clarity and
sharpness of the picture.
• Choose Standard for general TV watching mode.
• Choose Movie when watching movies,
= Standard 100
= Movie 45
c:== 75
=55
G50===R50
.. More
~ Move C3' Enter :J Return
Contrast
Bnghtness
Sharpness
Color
Tint
--- Pi~!~~_,_--
TV
.}
Press the ~ button to select Start, then press the
ENTER button to start the auto program.
The TV begins memorizing all available stations.
Press the ENTER button at any time to interrupt the
memorization process.
When pressing the ENTER button during a storing
process, the message Stop Auto Program? is
displayed.
Select Yes by pressing the'" or ~ button.
Press the EXIT button to exit.
• The TV must be connected to an antenna/cable
in order to receive digital TV signals. Even if a
particular
channel is deleted from the memory,
you can always tune to that channel directly by
using the number buttons on the remote control.
II Press the EXIT button to exit.
...- All available DTV and analog channels are
automatically stored in memory It takes
approximately 3 to 10 minutes to memorize
channels
English· 12