EasyManuals Logo

S&C TripSaver II Installation, Operation, And Configuration

S&C TripSaver II
89 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
2 S&C Instruction Sheet 461-509
Introduction
Qualified Persons
WARNING
Only qualified persons who are knowledgeable in the installation, operation, and
maintenance of overhead and underground electric distribution equipment, along
with all associated hazards, may install, operate, and maintain the equipment
covered by this publication. A qualified person is someone who is trained and
competent in:
The skills and techniques necessary to distinguish exposed live parts from nonlive
parts of electrical equipment
The skills and techniques necessary to determine the proper approach distances
corresponding to the voltages to which the qualified person will be exposed
The proper use of special precautionary techniques, personal protective
equipment, insulated and shielding materials, and insulated tools for working on
or near exposed energized parts of electrical equipment
These instructions are intended ONLY for such qualified persons. They are not
intended to be a substitute for adequate training and experience in safety procedures
for this type of equipment.
Read this
Instruction Sheet
NOTICE
Thoroughly and carefully read this instruction sheet before installing, operating
or configuring your TripSaverII Communications via Gateway system. The latest
version is available online in PDF format at sandc.com/en/support/product-
literature/. Familiarize yourself with Safety Information and Safety Precautions on
pages 4 through 6.
Retain this
Instruction Sheet
This instruction sheet should be available for reference wherever the TripSaver II
Communications via Gateway system is used. Retain this instruction sheet in a location
where you can easily retrieve and refer to it.
Video
A video about how to pair a communications gateway with a TripSaver II Cutout-Mounted
Recloser is available at sandc.com/GatewayPairing-video. The goal of the video is to
provide a clear and simple visual reference. In no way is the video meant as a complete
replacement of these written instructions.
Proper Application
WARNING
The equipment in this publication is only intended for a specific application. The
application must be within the ratings furnished for the equipment. Ratings for the
TripSaver® II Communications Gateway are listed in Specification Bulletin 461-33.
The ratings are also on the S&C nameplate affixed inside the product.
The operating temperature range for the Communications Gateway is -40°C to +50°C
(-40°F to +122°F).

Table of Contents

Other manuals for S&C TripSaver II

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the S&C TripSaver II and is the answer not in the manual?

S&C TripSaver II Specifications

General IconGeneral
BrandS&C
ModelTripSaver II
CategoryIndustrial Electrical
LanguageEnglish

Related product manuals