S&C TripSaver II - Software Menu Functions

24 S&C Instruction Sheet 461-509
The Gateway Settings screen contains the “Gateway Name,” “Ethernet 1 (LAN),” “Ethernet
2 (WAN),” ”IEC104 Protocol,” “Time Synchronization Source,” “Gateway Conguration,”
“Firmware Upgrade,” “Reboot Gateway” and “Ping Station” panels.
Note: For all eld edits within each menu, the Save button must be clicked for eld
modications to occur.
Gateway Name
The Gateway Name panel allows unique naming of the communications gateway. The
data from this eld will be delivered to the SCADA master via a DNP3 Group 0 read.
Enter a user-defined name for the communications gateway and click on the Save
button. Naming of the communications gateway is limited to 50 characters. S&C
recommends an intuitive naming convention for the communications gateways. See
Figure 14.
Figure 14. The Gateway Name field.
Gateway Settings
Conguring the Communications Gateway