S&C TripSaver II - Device Management

S&C Instruction Sheet 461-509 45
Figure 37. A ping Success message.
The purpose of the Device Management screen is to provide the ability to add, modify,
update, or delete a TripSaverII recloser. Additionally, a listing of TripSaverII reclosers
with respective connection status is displayed in the screen.
Note: To pair a TripSaverII recloser with the communications gateway, the recloser
must be in Gateway mode. Gateway mode is set using the service center configuration
software and the service center configuration kit (USB transceiver and power module).
Refer to S&C Instruction Sheet 461-504, “TripSaver® II Cutout-Mounted Recloser:
Protection Setup Using Service Center Configuration Kit,” for complete instructions
on connecting to a TripSaverII recloser with the USB transceiver and power module
and enabling Gateway mode.
NOTICE
The unpairing or deleting of a TripSaver II recloser(s) from the communications
gateway will remove the recloser’s wireless communications capability. To re-enable
wireless (Gateway mode), the TripSaverII recloser(s) must be removed from the
pole and accessed via the TripSaver II Service Center Configuration Software,
USB transceiver, and corded power module. Refer to S&C Instruction Sheet
461-504, “TripSaver® II Cutout-Mounted Recloser: Protection Setup Using Service
Center Configuration Kit,” for complete instructions on connecting to a TripSaverII
recloser with the USB transceiver, corded power module, and ac adapter. See the
“Commissioning (Pairing) a TripSaverII Recloser for Use with the Communications
Gateway” section on page 78 for a description of the pairing process.
Device Management
Con guring the Communications Gateway