44 S&C Instruction Sheet 461-509
Reboot Gateway
The red Reboot button enables the user to restart the communications gateway. See
Figure 35. When selected, a dialog box appears to con rm the Reboot command. After
the user clicks on the OK button, the user interface will show a Gateway Unavailable
screen. The entire reboot process requires approximately 5 minutes before communica-
tions to the communications gateway are re-established. When the reboot is complete,
the user interface will automatically load the Login screen. See Figure 11 on page 21.
Figure 35. The Reboot Gateway button.
Ping Station
The Ping Station feature allows the user to ping the SCADA master station or any
connected IP address. This feature allows the user to con rm the gateway is correctly
connected to the user’s network. Type in the IP address of the SCADA master station or
other device, and click on the Ping button. See Figures 36 and 37. A Success message will
appear, and the results of the ping will display as text in the Ping Station panel. If the ping
is unsuccessful, a Results message will appear in the panel showing what went wrong.
Figure 36. Location of the Ping Station button.
Con guring the Communications Gateway
To Next Page
Loading...
