S&C TripSaver II - Restore Profile

46 S&C Instruction Sheet 461-509
To add a TripSaverII recloser, click on the Add TripSaverII button on the top right
of the page. A dialog box will appear. Enter the recloser’s Transceiver ID and the desired
device name. See Figure 38 and Figure 39. The Transceiver ID must contain a total of
32 hexadecimal digits, separated by three periods. After the process is completed, the
user will be returned to the top of the TripSaverII Device Management panel when the
Add button is clicked. For full instructions on pairing a TripSaverII recloser with the
communications gateway, see the “Commissioning (Pairing) a TripSaverII Recloser for
Use with a Communications Gateway” section on page 78.
Note: The TripSaverII Device Name eld is optional and may be left blank.
Figure 38. Pairing of a TripSaverII recloser with the communications gateway.
Figure 39. The screen showing the successful addition of a TripSaverII recloser and status.
The top TripSaverII Device Management screen will display on a single line the
added recloser and any other TripSaverII reclosers that have their radios associated with
this communications gateway. In addition to the serial number and TripSaverII recloser
name, the recloser’s Transceiver ID, link status, and RSSI are displayed.
A TripSaverII recloser may be changed or removed by clicking on the Edit or Remove
button. Clicking on the Identify button will cause the TripSaverII recloser to update
its LCD screen to all blue, then all white, and repeat. This can help to identify a specific
TripSaverII recloser.
Conguring the Communications Gateway