S&C TripSaver II - Page 48

48 S&C Instruction Sheet 461-509
When the Service Center Configuration mode is enabled, a dialog box appears.
See Figure 41.
Figure 41. The dialog box showing the enable service center configuration pop-up.
When the service center configuration software is opened and the Connect to Device
option is selected from the menu bar, a selection of TripSaverII reclosers connected to the
gateway will be displayed. Select the desired recloser and click on the Connect button.
The Identify button can be used to help identify a TripSaverII recloser. It will cycle the
recloser’s LCD screen to solid blue, and then back again. See Figure 42.
NOTICE
When using a communications gateway to connect to a TripSaverII recloser via
the service center configuration software, any configuration changes made to the
communications gateway during the service center configuration software
session will not be captured. The communications gateway will act as a simple router
directing the radio connection to the TripSaverII recloser. S&C recommends not
making any changes to the communications gateway when using it to connect to a
TripSaverII recloser via the service center configuration software.
Figure 42. The service center configuration software Connect to Device screen.
Conguring the Communications Gateway