S&C TripSaver II - Page 86

86 S&C Instruction Sheet 461-509
Table 6. Radio Mode
Gateway
Mode
Configuration
Setting:
Enabled or
Disabled?
Line
Power
Available?
Cordless
Power
Module
Available?
①
Side
Magnet
Applied?
Side
Magnet
Configuration
Setting:
Is Enabled?
Radio Mode
(Firmware
v1.7)
Radio Mode
(Firmware v1.8)
Disabled Yes No No
●
Radio off Radio off
Disabled
●
Yes No
●
USB
transceiver
USB
transceiver
Disabled Yes No Yes No Radio off Radio off
Disabled Yes No Yes Yes
USB
transceiver
USB
transceiver
Disabled
●
Yes Yes No
USB
transceiver
USB
transceiver
Enabled Yes No No
●
Communications
gateway
Communications
gateway
Enabled
●
Yes No
●
USB
transceiver
USB transceiver
Enabled Yes No Yes No
Communications
gateway
Communications
gateway
Enabled Yes No Yes Yes
Communications
gateway
Communications
gateway
Enabled
●
Yes Yes No USB transceiver
Communications
gateway
Appendix A
① The corded ac power module should never be
connected to the TripSaver II recloser when the
recloser is powered by line current. See the Danger
message on page 85.
● This could be set to “Yes” or “No” without
affecting the Radio mode.