Sanding STS-752RC - Height Transfer

35
Angle Unit
dd. mm. ss
deg
gon
mil
° ′ ″ (degree, sexagesimal), possible angle values: 0°~
359°59′59″
DD (degree, decimal): possible angle
values:0º~359.9999º
gon, possible angle values: 0gon~399.9999gon
mil, possible angle values: 0mil~6399.99mil
The setting of the angle units can be changed at any
time.
The actual displayed values are converted according
to the selected unit.
Dist. Unit
Meter
US-ft
INT-ft
ft – in 1/8
M: Meter
US-ft: Us-feet
INT-ft: International feet
ft-in 1/8: US-feet-inch-1/8 inch
Temp. Unit
℃
℉
℃ Degree Celsius
℉ Degree Fahrenheit
Press Unit
hPa
mbar
mmHg
inHg
hPa: Hecto Pascal
mbar: Milliba
mmHg: Millimeter mercury column
inHg: Inch mercury column
Code Rec.
Save before
Save after
Sets if the code block is saved before or after the
measurement
GSI 8/16
GSI 8
GSI 16
Select GSI output format.
GSI 8: 81..00+12345678
GSI 16: 81..00+1234567890123456
Mask1/2
Mask1
Mask2
Select GSI output mask.
·Mask1: PtlD, Hz, V, SD, ppm+mm, hr, hi
·Mask2: PtlD, Hz, V, SD, E, N, H, hr
After the setting, press F4(Set.) to save the change.
4.5 HEIGHT TRANSFER
This function determines the height of the instrument from measurements to a
maximum of 5 target points with known heights, in two faces.
While measuring to several targets with known heights, the improvement is
indicated in the “delta” value.