Entering or Changing the Password
– Password for access to the following
functions, entered with 8 characters
max.:
– SETUP parameters
– Data record configuration
– Edit or copy drying program
§ Select the Setup menu:
Press the s
> SETUP is displayed
§ Select parameters:
Press the q und O soft keys
If you have already assigned
a password:
> The password prompt is displayed:
$ Enter the password
$ Confirm the password and
display the parameters:
Press the l soft key
§ Write down the password here
for easy reference:
Password = .............................
If you assign a password and then
forget what the word is:
$ Enter the General Password
(see Appendix)
$ Confirm the password and display
the parameters:
Press the l soft key
> Parameters are displayed
§ Select the password-setting function:
Press the q or Q soft key repeatedly
and O soft key until
> Password: and any existing
password are displayed:
15
§ New password: Enter the numbers
and/or letter of the new password
(8 characters max.)
If “none” is displayed as a password:
this means no password has been
assigned
To delete the user password:
Enter . and confirm
§ To confirm your entry:
Press the l soft key
§ Exit the Setup menu:
Press the oo soft key
> Restart the application
Extra Functions
§ Exit the Setup menu:
Press the oo soft key
> Restart the application
§ Printout the parameter setting:
– If “Device parameters” are displayed:
Press the p soft key
> Printout (example)
Printouts with more than 20 characters
are cut off
--------------------
SETUP
DEVICE
--------------------
User ID
User ID:
ABC123456
Weighing parameters
Adapt filter
Normal vibration
Calibration/Adjust
Wt.ID (W ID):
123
Cal./Adj. wt.:
50.000 g
Interface
SBI
Baudrate
1200 baud
Number of data bit
7 bit
Parity
Odd
Number of stop bit
1 stop bit
Handshake mode
Hardware 1 char
etc.
● Reset the device parameters to
the factory settings:
See the section on selecting the factory
settings in the chapter entitled “Device
Parameters (Overview)”
To Next Page
Loading...
