Example 2: Quick Drying with Fully Automatic Shutoff Mode
The moisture content of 2.5 g of fine ceramic material is to be determined. This non-heat-sensitive sample is to be analyzed as soon quickly
possible. The analysis is to be ended automatically as soon as a constant weight is reached.
Settings (factory setting):
Program number: 2
Program name: fine ceramic material
Heating program: quick drying
Final temperature: 200°C
End of analysis: automatic (different from the factory settings)
Result displayed: dry weight (%R)
Step Key (or instruction) Display/Printout
1. Turn on the moisture analyzer e key Sartorius logo is displayed
Self-test runs
The above mentioned parameters Enter the parameters:
for drying program 2 see Example 1
“fine ceramic material” have
already been set
2. Select program display
Prog. soft key
3. Select program “2”
q soft key
4. Load program “fine ceramic
Load soft key
material” as the current drying
program
5. Confirm load prompt
Yes soft key
6. Prepare the sample:
Cut the fine ceramic material
into thin slices
41
To Next Page
Loading...
