30 Picus
®
2 Operating Instructions
Commissioning
6.3 Switching the Device On or Off
Procedure
t To switch the device on:
t Press the On | Off button.
t If password protection is activated: log in with the password.
t When the device is switched on for the first time: enter the date and
the time in the query.
y The device actuates the piston.
y The device is ready for use.
t To switch the device off:
t If password protection is activated: log out of the profile being used.
To do this, briefly press the On | Off button.
t Press and hold the On | Off button for a few seconds.
6.3.1 Returning to Active Mode
During use and charging, the device is in active mode. All processor
functions are activated and the backlighting on the display is switched on.
When the device is not used (for a long time) it behaves as follows:
— If the device is not used for more than 30 seconds: the device is in
energy saving mode and the backlight is dimmed.
Pressing any key or turning the scrollwheel let return to the active mode.
— If the device is not used for more than 10 minutes: the backlight switches
off.
Pressing the On | Off button lets return to active mode.
— If the device is not used for more than 4 hours: the device switches itself
off.
6.4 Rinsing Tips
Sartorius recommends to rinse the tips before operating.
Requirements
Tips are attached to the cone.
Procedure
t Open the main menu.
t Set the operating modus “ Pipetting”.
t Aspirate water. To do so, press the operating button.
t Dispense water. To do so, press the operating button again.
t Repeat aspirating and dispensing 3 - 5 times.
y The Tips are rinsed.
To Next Page
Loading...
Need help?
General
