Unit 4: Standard Command Codes
E/Pro Programming Reference
4-87 PN: 9001096E
CUT, JOB
FUNCTION
Regulates label cutting when using a cutter assembly with the printer. This command allows
the cutting of a multi-part tag or label at a specified interval within a print job.
FORMAT
<ESC>~aaaa
aaaa = Number of labels to print between each cut (1 to 9999)
Place following the Print Quantity command <ESC>Q.
EXAMPLE
<ESC>A
<ESC>H0020<ESC>V0020<ESC>XB1ABC<ESC>Q3
<ESC>~0002
<ESC>Z
OUTPUT
This set of commands will print 6 labels (3 x 2) with two labels between each cut.
(4-55)
NOTES
The optional label cutter must be installed and the printer configured for its use for this function to be
valid. If the cut value is (a = 0), the cutter is inactive.
A “~” (tilde) character or <NUL> (ASCII 00 Hex) character can be used in this command. It is
recommended that the “~” be used whenever possible.
When using the Cutter command, the total number of labels printed is the product of the cut value and
the print quantity.
To Next Page
Loading...
