Unit 4: Standard Command Codes
E/Pro Programming Reference
4-20 PN: 9001096E
JOURNAL PRINTING
FUNCTION
To print text in a line by line format on a label. By specifying this command, you automatically
select Font XS with a Character Expansion of 2x2. You also establish a base reference point
of H2,V2. The character pitch is 2 dots and the line gap is 16 dots. Simply issue an ASCII
<CR> at the end of each text line.
FORMAT
<ESC>J
Place immediately following <ESC>A.
EXAMPLE
<ESC>A
<ESC>J WITH THE JOURNAL FEATURE YOU CAN PRINT TEXT WITHOUT USING ANY
FONT COMMANDS OR POSITION COMMANDS
<ESC>Q1
<ESC>Z
OUTPUT
(4-12)
NOTES
Journal mode assumes a maximum label width. Otherwise, you may print where there is no label and
damage your print head.
It is effective only for the current print job.
To Next Page
Loading...
