Unit 4: Standard Command Codes
E/Pro Programming Reference
4-123 PN: 9001096E
PRINT LENGTH, EXPANSION
FUNCTION
To increase the maximum print length (in feed direction) for a label.
FORMAT
<ESC>EX0 Sets the print length to maximum
<ESC>AR Resets the maximum print length to 7" (178 mm)
Must follow the Start Code command within it is own separate data stream.
EXAMPLE
<ESC>A
<ESC>EX0
<ESC>Z
<ESC>A
<ESC>H0050<ESC>V0100<ESC>WB1EXPAND TO:
<ESC>H0050<ESC>V2700<ESC>WB1MAX INCHES
<ESC>Q1
<ESC>Z
<ESC>A
<ESC>AR
<ESC>Z
OUTPUT
(4-62)
NOTES
“EX0” is effective until “AR” is sent to reset the printer to its standard print length, or until the printer is
re-powered.
When this command is used with the Store Form Overlay (<ESC>&) command the form length cannot
exceed the maximum specified.
If a job contains elements out of the memory range, it is ignored.
If the Forms Overlay (<ESC>&) command is used with Expanded Memory to expand the print area, the
Form Overlay length is still limited to the maximum.
Refer to Appendix: Reference Tables 49 and 50 for additional information.
To Next Page
Loading...
