SATO CL408 - ACCESSORY (EXT) CONNECTOR; PIN ASSIGNMENTS

Programming Manual 2. Command Codes
SATO RISC Printers 105
Memory Card Function
Format/Field Store
Command Structure:
<ESC>YS,aa<ESC>/N,bb,cc{.......}
aa: Format number to be stored (01-99)
bb: Field number to be stored (01-99)
cc: Length of field to be stored (01-99)
{.....}: Command stream describing the field to be stored.
Example: <ESC>YS,01<ESC>/N,01,05
Placement: Immediately after <ESC>CC Slot Select command.
Default: None
Function:
To store a format field description in the memory card.
Input:
<ESC>A
<ESC>CC1
<ESC>YS,02<ESC>/N,01,13<ESC>V0100<ESC>H0100<ESC>XB1
<ESC>/N,02,13<ESC>V0200<ESC>H0200<ESC>XB1
<ESC>Z
Output:
There is no printer output as a result of this command. See <ESC>YR
Format/Field Recall command.
Note:
1. This command requires the Memory Card option. See your SATO
representative for details.
2. Each job should be sent individually. If more than one job is sent
in a data stream, only the first one will be accepted and the
remainder ignored.
3. The following commands cannot be stored in a format:
<ESC>CS Print Speed
<ESC>C Repeat Label
<ESC>NULL Cut Label
<ESC>Q Print Quantity
<ESC>/D Recall Field
<ESC>EX Expanded Label Storage
<ESC>T Custom Characters
<ESC>& Store Form Overlay