SATO CL408 - Error Signals CL608;612 (VA)

Programming Manual 6. Troubleshooting
SATO RISC Printers 193
6.7 Error Signals CL608/612 (VA)
LED LCD MESSAGE AUDIBLE
BEEP
ERROR
CONDITION
TO CLEAR
Erroron MaschineError 1Long MaschineErro Cyclepoweron/
off
Error on EEPROM Error 1 Long EEPROM
Read/Write
Cycle power on/
off
Error on Head Error 1 Long Head Cycle power on/
off
Error on Sensor Error 3 Short Sensor Cycle power on/
off
Error Blinks Card R/W Error 1 Long Memory Card
Read/Write
Cycle power on/
off
Error Blinks Card Low Battery 1 Long Memory Card
Battery Low
Cycle power on/
off
Error Blinks Head Open 3 Short Head Open Close Head
Lever
Error Blinks Cutter Error 3 Short Cutter Cycle power on/
off
Error On
Error Blinks
PARITY ERROR 3 Short RS232 Parity
Error
Cycle power on/
off
Error On
Error Blinks
Overrun Error 3 Short RS232 Over-
run Error
Cycle power on/
off
Error On
Error Blinks
Framing Error 3 Short RS232 Fra-
ming Error
Cycle power on/
off
Error On
Error Blinks
Buffer Over 3 Short Buffer Over-
flow
Cycle power on/
off
Error Blinks
Label On
Paper End 3 Short Label End Open/Close
Head Lever or
Label Holddown
Error Blinks
Ribbon On
Ribbon End 3 Short Ribbon End Open/Close
Head Lever or
Label Holddown
Error Blinks
Label Blinks
Media Error 3 Short Media Error Open/Close
Head Lever
Ribbon Blinks None Ribbon Near
End
Replace Ribbon
with full roll
Line Blinks None Buffer Near
Full
Slow down trans-
mission rate