Programming Manual 1. Introduction
SATO RISC Printers 7
1. Introduction
This manual presents the commands that are used with the SATO RISC
Printers to produce labels with logos, bar codes and alphanumeric data.
All of the RISC commands use the same syntax. Some commands refer-
ence a physical point on the label using horizontal and vertical dot refer-
ence numbers. The allowable range for these references is dependent
upon the particular printer to accomodate different print widths and reso-
lutions. These differences are noted in tables under the commands
affected.
H
Introduction
H
Command Codes
H
Command Codes Quick Reference
H
Command Codes Specifications
H
Interface Specification
H
Troubleshooting
H
Custom Protocol Command Codes
H
Custom Characters And Graphics
To Next Page
Loading...
