SATO CL408 - Page 126

126 SATO RISC Printers
3. Command Code Quick Reference Programming Manual
WLa Font type. Specifies the 28W x 52H dot matrix font
(including decenders).
a = 0 Disables auto-smoothing of font
1 Enables auto-smoothing if expansion is
greater than 3
XBa Font type. Specifies the 48W x 48L dot matrix font
(including descenders).
a = 0 Disables auto-smoothing of font
1 Enables auto-smoothing if expansion is
greater than 3
XLa Font type. Specifies the428W x 48H dot matrix font
(including decenders).
a = 0 Disables auto-smoothing of font
1 Enables auto-smoothing if expansion is
greater than 3
XM Font type. Specifies the 24W x 24H dot matrix font
(including descenders).
XS Font type. Specifies the 17W x 17H dot matrix font
(including descenders).
XU Font type. Specifies the 5W x 9H dot matrix font (inclu-
ding descenders).
XWa Font type. Specifies the 48W x 48H dot matrix font
(including descenders).
a = 0 Disables auto-smoothing of font
1 Enables auto-smoothing if expansion is
greater than 3
Z Stop Code. Ends all print jobs.
%a Rotate - Fixed Base Reference Point. Rotates prin-
ting in 90° increments without changing the base refe-
rence point.
a = 0 Sets print to normal direction
1 Sets print to 90° CCW
2 Sets print to 180° rotated (upside down)
3 Sets print to 270° CCW (90° CW)
$a,b,c,d Vector font. Specifies printing of the unique SATO
vector font.
a = A Helvetica Bold (proportional spacing)
B Helvetica Bold (fixed spacing)