Programming Manual 2. Command Codes
SATO RISC Printers 91
Output:
Note:
1. The value specified for Print Quantity should be equal to the num-
ber of different sequential values desired multiplied by the num-
ber of repeats specified.
Example:
To print 2 sets each of the numbers 1001-1025 on separate labels,
we need 50 total labels. The commands would be as follows:
<ESC>A
<ESC>H0100<ESC>V0100<ESC>F002+001<ESC>XM1001
<ESC>Q50
<ESC>Z
2. It is necessary to specify the print position for each sequential
field on a label.
3. Up to eight different sequential fields can be specified per label.
4. This command ignores alpha characters in the sequential num-
ber field.
5. This command can not be used with the following commands:
Copy Image,
Reverse Image,
Line Feed.
To Next Page
Loading...
