SATO CL6NX - Page 659

659
Initial ValueSetting Item
CL4NX CL6NX
User
Reset
Factory
Reset
[Speed]
203 dpi
6 ips
305 dpi
6 ips
609 dpi
4 ips
Linerless mode
4 ips
203 dpi
6 ips
305 dpi
6 ips
Yes Yes
[Sensor Type] Gap
None (When [Print
Mode] is [Linerless])
Gap Yes Yes
[Auto-mode] Enabled Yes Yes
[Print Mode] Tear-Off (If no option
is installed)
Cutter (If cutter unit is
installed)
Dispenser (If
dispenser unit is
installed)
Linerless (If linerless
cutter kit is installed)
Tear-Off (If no option
is installed)
Cutter (If cutter unit is
installed)
Dispenser (If
dispenser unit is
installed)
Yes Yes
[Backfeed] Before (If [Print Mode]
is set to [Tear-Off] or
[Linerless])
After (If [Print Mode]
is set to [Dispenser],
[Cutter] or [Cut &
Print])
None (If [Print Mode]
is set to [Continuous])
Before (If [Print Mode]
is set to [Tear-Off])
After (If [Print Mode]
is set to [Dispenser],
[Cutter] or [Cut &
Print])
None (If [Print Mode]
is set to [Continuous])
Yes Yes
[Eject Cut] Off Yes Yes
[Darkness Range] A Yes Yes
[Darkness] 5 Yes Yes
[Imaging]
[Vertical] 0 dot Yes Yes
[Horizontal] 0 dot Yes Yes