SATO PW208NX - Page 112

Starting Up the Printer
109
Mobile printer PW208NX/PW208mNX
BD Address
Tools > Test Print> BD Address
To perform the BD Address test print, the setting items are as follows:
1 Print
Perform the test print.
To stop the test print, press the
button or
button.
2 Pitch Adjust the print position.
Initial value : 0 dot
Setting range : –30 to 30 dots
3 Offset Adjust the stop position of media.
Initial value : 0 dot
Setting range : –30 to 30 dots
4 Darkness Adjust Fine tune the print darkness of the print.
Initial value : 50
Setting range : 0 to 99 dot
Note
0 is the lightest and 99 is the darkest.
Notes
• The values of Pitch, Offset and Darkness Adjust set in the BD Address
menu are reected to the same item settings in the Factory menu,
Congure List menu, Congure QR menu and Paper Sensor menu.
• The values of Pitch, Offset and Darkness Adjust set in the BD Address
menu are reected to the same item settings in the Adjustment mode
(

page 63).