SATO PW208NX - Page 66

Starting Up the Printer
63
Mobile printer PW208NX/PW208mNX
Adjustments
Printing > Advanced > Adjustments
To set the adjustments mode, set the following items.
1 Offset Set the offset position.
2 Pitch Set the print position.
3 Darkness Adjust Fine tune the print darkness of the print.
Note
The values for Offset and Pitch specied in the Adjustments are
reected in the relevant setting items in Test Print (pages 108 to 113).
Offset
Printing > Advanced > Adjustments > Offset
Adjust the stop position.
The stop position refers to the tear-off position, cut position and dispenser stop
position.
Set an offset value + to move the print position opposite the feed direction and value –
to move the print position in the feed direction.
Initial value : 0 dot
Setting range : –30 to 30 dots
ABC
（＋）
（ー）
Media feed direction
Pitch
Printing > Advanced > Adjustments > Pitch
Move the print position in the vertical direction.
Set an offset value + to move the print position opposite the feed direction and value –
to move the print position in the feed direction.
Initial value : 0 dot
Setting range : –30 to 30 dots