SATO PW208NX - Page 115

112
Mobile printer PW208NX/PW208mNX
Starting Up the Printer
Congure QR
Tools > Test Print > Congure QR
To perform the Congure QR test print, the setting items are as follows:
1 Print
Perform the test print.
To stop the test print, press the
button or
button.
2 Label Length Set the length of one sheet of media used for the test print.
Initial value : 800 dot
Setting range : 400 to 1600 dots
3 Pitch Adjust the print position.
Initial value : 0 dot
Setting range : –30 to 30 dots
4 Offset Adjust the stop position of media.
Initial value : 0 dot
Setting range : –30 to 30 dots
5 Darkness Adjust Fine tune the print darkness of the print.
Initial value : 50
Setting range : 0 to 99 dots
Note
0 is the lightest and 99 is the darkest.
Notes
• The values of Label Length, Pitch, Offset and Darkness Adjust set in
the Congure QR menu are reected to the same item settings in the
BD Address menu, Factory menu, Congure List menu and Paper
Sensor menu.
• The values of Pitch, Offset and Darkness Adjust set in the Congure
QR menu are reected to the same item settings in the Adjustment
mode (

page 63).