SATO PW208NX - Page 117

114
Mobile printer PW208NX/PW208mNX
Starting Up the Printer
HEX-Dump
Tools > HEX-Dump
To save the received buffer data, the setting items are as follows:
1 Hex Dump
Mode
Enable or disable the Hex Dump mode.
2 Buffer Dump Save the received buffer data to the printer.
3 Log Files Manage the log les of the received data created in the HEX-
Dump mode and Buffer Dump.
Hex Dump Mode
Tools > HEX-Dump > Hex Dump Mode
Enable or disable the Hex Dump mode.
If you set the Hex Dump mode to Enabled, the printer prints the received data and at
the same time creates a le of the received data inside hexdump/.
Initial setting : Disabled
Setting options : Enabled, Disabled
Notes
• If you set the Hex Dump mode to Enabled, HEX is added to the status
icons.
• You can save a maximum of ten received data les for each type of
interface. Depending on the le size, the number of les you can save is
less than ten.
• The details of the les created inside hexdump/ are as follows:
• BT00xx.bin: Received data through Bluetooth.
• WIFI00xx.bin: Received data through wireless LAN.
• USB00xx.bin: Received data through USB.
• When the received data size reaches to 1024 KB or the status without
receiving data lasts for 60 seconds, the le is saved.
• You can print or delete les from the Log Files menu.