SATO PW208NX - Page 129

126
Mobile printer PW208NX/PW208mNX
Starting Up the Printer
Setting Items Initial Setting/Value User Reset Factory Reset
USB – – –
Flow Control Status4 Yes/comm
*
Yes/comm
*
Bluetooth – – –
Enable Enabled Yes/comm
*
Yes/comm
*
Name
SATO PRINTER_xxxxxxxxxxxx
(xxx: BD address is displayed.)
Yes/comm
*
Yes/comm
*
PIN Code 0000 Yes/comm
*
Yes/comm
*
BD Address xxxxxxxxxxxx Yes/comm
*
Yes/comm
*
Firm Version spp3_vX.YY Yes/comm
*
Yes/comm
*
Host BD addr – Yes/comm
*
Yes/comm
*
IAP Ready Enabled – –
iOS Reconnect Disabled Yes/comm
*
Yes/comm
*
Authentication None Yes/comm
*
Yes/comm
*
ISI 2048 Yes/comm
*
Yes/comm
*
ISW 18 Yes/comm
*
Yes/comm
*
PSI 144 Yes/comm
*
Yes/comm
*
PSW 18 Yes/comm
*
Yes/comm
*
Give BD Address Enabled Yes/comm
*
Yes/comm
*
IO Compatible Disabled Yes/comm
*
Yes/comm
*
CRC Mode Disabled Yes/comm
*
Yes/comm
*
Flow Control Status4 Yes/comm
*
Yes/comm
*
NFC – – –
I/F Enable Enabled Yes/comm
*
Yes/comm
*
Ignore CR/LF Disabled Yes/comm
*
Yes/comm
*
Ignore CAN/DLE Disabled Yes/comm
*
Yes/comm
*
*: These settings and values of communications settings in usable status are not reset when performing
Factory reset.