134
Mobile printer PW208NX/PW208mNX
Troubleshooting
Error Message
*
To clear the display Causes Countermeasures
Error
Number
Error Icon
Type of Error
Message
1058 CRC Check Error
Press the
button.
1) CRC has not been
added to the data.
2) CRC does not
match.
1), 2)
Check transmitted
data and interface
conditions
Check the print data.
1059
Charging Stop the operation of the
printer for a while.
1) The printer is in
the low battery
status and is being
charged.
2) Charge the printer
so that it can
perform printing.
Wait until the low battery
level is cleared.
1060 No Battery Insert the battery. 1) The battery is
disconnected.
2) The battery is not
inserted.
1), 2)
Insert the battery.
Insert the battery.
1061
Degraded Batt. Replace the battery. 1) The battery is
degraded.
1) Replace the
battery.
Contact your SATO
reseller or technical
support center.
1063
Battery Error Power off the printer.
The power is automatically
turned off after 30 to 40
seconds.
1) The battery is
defective.
1) Replace the
battery.
Replace the battery.
1064
Printer Overheat Stop the operation of the
printer for a while.
1) The temperature
of the motor has
exceeded its
tolerance value.
1) Stop the operation
of the printer for
a while to let the
temperature of the
printer decrease.
Wait until the
motor temperature
decreases.
1065
Printer Overheat Power off the printer.
The power is automatically
turned off after 30 to 40
seconds.
1) The temperature
of the printer has
exceeded its
tolerance value.
1) Stop the operation
of the printer for
a while to let the
temperature of the
printer decrease.
2) Contact your
SATO reseller or
technical support
center.
Contact your SATO
reseller or technical
support center.
1066
Paper Jam Open the cover and load
the media again.
1) The media
has jammed
during Linerless
operation.
1) Open the cover
and load the
media again.
Open the cover and
load the media again.
1067
Charging Wait until charging is
complete.
1) You cannot power
off the printer
during charging.
2) Power off the printer
after charging is
complete.
Wait until charging is
complete.
* : For details on error messages, see “3.1.1 Error Messages” (
page 130).
To Next Page
Loading...
