SATO PW208NX - Page 59

56
Mobile printer PW208NX/PW208mNX
Starting Up the Printer
Advanced
Printing > Advanced
To set detailed sensor operation and print motion, the setting items are as follows:
1 Calibrate Set the media sensor adjustments.
2 Head Check Set the head check operation.
3 Head Chk Mode Set the head check method. This item is displayed
only if Head Check is set to All or Barcode.
4 Every Page Set the interval to perform head check by specifying
the number of media. This item is displayed only if
Head Chk Mode is set to Every Page.
5 Chk Media size Enable or disable media size check. This item is
displayed only if Sensor Type is set to Gap or I-Mark.
6 Adjustments Adjust the offset, print position and print darkness.
7 Start Online Set the status when the printer starts.
8 Feed After Error Set whether the media roll is to be fed by one sheet
and switches automatically to the printing (online)
screen when the printer recovers from an error.
9 Feed At P-On Set whether the media roll is to be fed by one sheet
when the printer starts.
10 Finisher Feed Set the length to feed after printing in the tear-off or
Dispenser mode.
11 Paper End
(PW208NX only)
Select the sensor for detecting the paper end.
12 Prioritize Set which takes priority, printer setting or command
setting.
13 Reprint Enable or disable the reprint function.
14
Print End Pos.
(Print End Position)
Set the print end position of media.
15 Dispenser Mode Set the dispenser motion.