SATO PW208NX - Page 78

Starting Up the Printer
75
Mobile printer PW208NX/PW208mNX
Wi-Fi Direct
Interface > Network > Settings > Wi-Fi > Wi-Fi Direct
To set up the Wi-Fi Direct function, the setting items are as follows:
The Wi-Fi Direct function is enabled only if you have selected Infrastructure in the
Mode menu.
1 Device Name Shows the device name.
You cannot change the setting.
2 Connect Search and display a connectable device and then connect
to the device.
3 Start Group
While <new> is displayed on the screen, press the
button to create and start a new persistent group.
If the group is already started, this setting item is not
displayed.
4 Button (PBC) When a group has been started, set the wireless LAN
connection using the push button method.
5 Disconnect Disconnect the connected device.
When a group has been started, disconnect the group.
6 Remove Group Remove a group.
Press the
button to select the group you want to
remove, then press the
button to remove the group.
If the group is already started, this setting item is not
displayed.
7 SSID When a group has been started, SSID is displayed.
SSID is a device name.
You cannot change the setting.
8 IP Address When a group has been started, IP address is displayed.
You cannot change the setting.
9 Passphrase When a group has been started, passphrase is displayed.
You cannot change the setting.
Connect
Interface > Network > Settings > Wi-Fi > Wi-Fi Direct > Connect
Search a connectable device and then connect to the device.
The setting procedures are as follows:
1. Select Connect to search the connectable device names.
2. Press the
button to select the device name you want to connect, and then
press the
button to decide the device.
3. Follow the instructions of the printer or the device you want to connect, complete
the connection.
Note
You can connect to the maximum of 10 devices.