SATO PW208NX - Page 86

Starting Up the Printer
83
Mobile printer PW208NX/PW208mNX
Bluetooth
Interface > Bluetooth
To set the Bluetooth connection, the setting items are as follows:
1 Enable Enable or disable the functions for Bluetooth.
2 Name Shows the device name for the printer when Bluetooth
function is enabled.
You cannot change the setting.
3 PIN Code Shows the PIN code when Bluetooth function is enabled.
You cannot change the setting.
4 BD Address Shows the BD address of this printer when Bluetooth
function is enabled.
You cannot change the setting.
5 Firm Version Shows the rmware version of the Bluetooth when
Bluetooth function is enabled.
You cannot change the setting.
6 Host BD Addr Shows the Host BD address when Bluetooth function is
enabled.
You cannot change the setting.
7 IAP Ready Shows the operational status of the IAP authentication chip,
enabling the communication between an iOS-equipped
device and a Bluetooth device. When the communication is
enabled, a check mark is displayed.
You cannot change the setting.
8 iOS Reconnect Disable the iOS reconnect function or set to the Manual
mode.
9 Authentication Set the authentication level when Enable is set to Enabled.
10 ISI Set the ISI communication parameter when Bluetooth
function is enabled.
11 ISW Set the ISW communication parameter when Bluetooth
function is enabled.
12 PSI Set the PSI communication parameter when Bluetooth
function is enabled.
13 PSW Set the PSW communication parameter when Bluetooth
function is enabled.
14 Give BD Address When enabled, the BD address is added to the printer
device name.
15 IO Compatible Set the authentication process in Secure Simple Pairing.
16 CRC Mode Set up the CRC check function when Bluetooth function is
enabled.
17 Flow Control Set the communication protocol when Bluetooth function is
enabled.