Scanreco G6 - Page 43

– 43 –
Scanreco – Service Manual G6 Radio Remote Control System
Code Cause of error Possible reason Correction
210 8 / 2308
A feedback signal for safety
classified outputs indicates
that the output is on when it
should be o.
Hardware error.
External EMC interference.
Replace the receiver if the
error continues.
210 9 / 2309
A validation check has failed in
the microprocessor RAM when
starting the receiver.
Hardware error.
External EMC interference.
Replace the receiver if the
error continues.
2110 / 2310
A read write check has failed
in the microprocessor when
starting the receiver.
Hardware error.
External EMC interference.
Replace the receiver if the
error continues.
2 111 / 2311
The microprocessor flash
image is faulty.
Hardware error.
External EMC interference.
Replace the receiver if the
error continues.
2112 / 2 312
A generic self-test of the micro-
processor has failed.
Hardware error. Replace the receiver if the
error continues.
2113 / 2 313
The microprocessor clock
speed is faulty.
Hardware error.
External EMC interference.
Replace the receiver if the
error continues.
2114 / 2314
Software stack overflow. Hardware error.
Software error.
Replace the receiver if the
error continues.
2115 / 2315
The EEPROM is faulty, prevent-
ing critical parameters to be
accessed.
Hardware error.
Software error.
External EMC interference.
Replace the receiver if the
error continues.
2116 / 2316
A software register is faulty. Hardware error.
Software error.
Replace the receiver if the
error continues.
2 117 / 2317
Receiver supply voltage is
too high.
Supply voltage too high.
Hardware error.
Decrease the supply voltage
to within specification. Re-
place the receiver if the error
continues.
2118 / 2 318
Receiver supply voltage is
too low.
Supply voltage too low.
Hardware error.
Increase the supply voltage
to within specification. Re-
place the receiver if the error
continues.
2119 / 2319
The receiver temperature is
too high.
The receiver is operating in
conditions outside of specifi-
cation.
Hardware error.
Wait for the receiver to cool
down. Replace the receiver if
the error continues.
2120 / 2320
The receiver temperature is
too low.
The receiver is operating
in conditions outside of
specification.
Hardware error.
Wait for the receiver to heat up.
Replace the receiver if the
error continues.
2121 / 2 3 21
The overvoltage protection for
the STOP output is faulty.
Hardware error. Replace the receiver if the
error continues.
2122 / 2322
The overvoltage protection for
the LOOP output is faulty.
Hardware error. Replace the receiver if the
error continues.