Scanreco G6 - Page 44

– 44 –
Scanreco – Service Manual G6 Radio Remote Control System
Code Cause of error Possible reason Correction
2123 / 2323
Power supply has been found
on both manual and remote
input.
Incorrect wiring.
Hardware error.
Make sure the power is sup-
plied to only one input at any
time.
Replace the receiver if the
error continues.
2198 / 2398
The SISP
TM
processor has not
been started correctly or is un-
able to communicate with the
application microprocessor.
Hardware error. Replace the receiver if the
error continues.
2199 / 2399
The SISP
TM
processor has
stopped working or is unable to
communicate with the applica-
tion microprocessor.
Hardware error. Replace the receiver if the
error continues.
3103 The receiver application
microprocessor EEPROM
is corrupted, clearing all
configuration parameters.
Incompatible software has
been installed.
Hardware error.
External EMC interference.
Correct the parameters and
install the updated software
on the receiver.
3201
The battery in compartment
one (1) has been found as a
non-original battery. The trans-
mitter will shut down automati-
cally after a few minutes.
A non-original or faulty battery
is used.
Dirty battery poles and / or
springs.
Clean battery poles and
springs.
Replace the battery with an
original Scanreco battery.
3202
The battery in compartment
two (2) has been found as a
non-original battery. The trans-
mitter will shut down automati-
cally after a few minutes.
A non-original or faulty battery
is used.
Dirty battery poles and / or
springs.
Clean battery poles and
springs.
Replace the battery with an
original Scanreco battery.
3203
The transmitter application
microprocessor EEPROM is
corrupted, clearing all configu-
ration parameters.
Incompatible software has
been installed.
Hardware error.
External EMC interference.
Correct the parameters and
install the updated software on
the transmitter.
3204
The transmitter microproces-
sor flash memory has been
corrupted.
Software update was not
successful.
Hardware error.
External EMC interference.
Update software correctly.
Replace the main board if error
continues.
8101
A CAN passive error has
occurred.
Incorrect CAN wiring.
Wrong baud rate setting.
Incorrect CAN termination.
Hardware error.
Ensure a correct CAN wiring
and setting.
Replace the receiver if the
error continues.
8102
A CAN buer overflow error
has occurred.
Incorrect CAN wiring.
Wrong baud rate setting.
Incorrect CAN termination.
Hardware error.
Ensure a correct CAN wiring
and setting.
Replace the receiver if the
error continues.
8103
A CAN bus o error has oc-
curred.
Incorrect CAN wiring.
Wrong baud rate setting.
Incorrect CAN termination.
Hardware error.
Ensure a correct CAN wiring
and setting.
Replace the receiver if the
error continues.