Scanreco G6 - Page 45

– 45 –
Scanreco – Service Manual G6 Radio Remote Control System
Code Cause of error Possible reason Correction
8104 A CAN PDO length error has
occurred in CAN1.
Incorrect RPDO length is
received.
Make sure the object
dictionary is reset.
Make sure that the correct
length on the RPDO is
accurate.
8105
A CAN PDO length error has
occurred in CAN2.
Incorrect RPDO length is
received.
Make sure the object dictionary
is reset.
Make sure that the correct
length on the RPDO is accurate.
8106
A CAN transmit collision
occurred.
Incorrect CAN wiring.
Wrong baud rate setting.
Incorrect CAN termination.
Too high CAN bus load.
Hardware error.
Ensure a correct CAN wiring
and setting.
Replace the receiver if the
error continues.
8107
A CAN passive error has
occurred.
Node guarding protocol is not
accurate.
Ensure correct node guarding
protocol is implemented.
9001
The transmitter radio module is
not responding.
The radio module is missing or
broken.
Replace the radio module if the
error continues.
9002
The transmitter's internal I2C
bus is faulty.
Hardware error. Replace the main board if the
error continues.
9101 – 9199
A major receiver software error. Software error. Hardware error. Update the receiver software.
Replace the receiver if the
error continues.
9301 – 9399
A minor receiver software
error.
Software error. Hardware error. Update the receiver software.
Replace the receiver if the
error continues.
9401 – 9499
A major transmitter software
error.
Software error. Hardware error. Update the transmitter soft-
ware.
Replace the main board if the
error continues.
9501
The receiver application was
unable to read time and date
from the RTC module.
No hardware support for RTC.
Hardware error.
The RTC battery service life
has expired
.
Make sure that the receiver
is equipped with RTC.
Disable the RTC parameters if
it is not supported.
Replace the receiver if the
error continues.
9502
The receiver application was
unable to set time and date to
the RTC module.
No hardware support for RTC.
Hardware error.
Make sure that the receiver is
equipped with RTC. Disable
the RTC parameters if it is not
supported.
Replace the receiver if the
error continues.
9503
The receiver application was
unable to read time and date
from the RTC module.
No hardware support for RTC.
Hardware error.
The RTC battery service life
has expired.
Make sure that the receiver is
equipped with RTC. Disable
the RTC parameters if it is not
supported.
Replace the receiver if the
error continues.