Schaerer Ambiente 2 - 4.5.1.4. Change quantity of coffee ground (coffee powder); 4.5.1.5. Change quantity water and;or milk for coffee products

User Instructions
BASO-2 - 02.04 - V07 Page 4-13
4.5.1.3. Reset counter
1. Insert CHEF card into the card reader.
2. Press
[ ] or [ ] until the following menu is displayed:
3. Press [ ] key:
4. Press [ ] key:
5. Press [ ] or [ ] key to reach next menu, remove CHEF card Î coffee machine
ready in normal operating mode.
4.5.1.4. Change quantity of coffee ground (coffee powder)
This function determines the amount of coffee powder that is dispensed for each indi-
vidual coffee product.
1. Insert CHEF card into the card reader.
2. Press
[ ] or [ ] until the following menu is displayed:
3. Press the key for the relevant product.
4. Press the [ ] or [ ] to raise or lower the amount of coffee powder dispensed by +/-
percent.
5. Press
[ ] key to confirm the setting or modification.
6. The new setting is now activated.
7. Repeat steps 3 to 6 if the quantity is incorrect or if other product quantities need to be
modified.
Press the [
] or [ ] key to reach next menu or remove CHEF card Î coffee ma-
chine ready in normal operating mode.
4.5.1.5. Change quantity Î water and/or milk for coffee products
This function determines the amount of water and/or milk dispensed for each individ-
ual product (all coffee products and milk).
1. Insert CHEF card into the card reader.
2. Press
[ ] or [ ] until the following menu is displayed:
3. Press the key for the relevant product.
4. Press the [ ] or [ ] to raise or lower the amount of water dispensed by +/- percent.
5. Press the [
] key to confirm the setting or modification.
delete counter
execute ` Decaf `
delete counter
delete ? ` Decaf `
change fill quantity
select product
delete counter
.. Done ..
total prod. counter
K: xxx T: xxx
change fill quantity
water quantity +0%
change grind quantity
select product
change grind quanti.
grind quantity +0%
ª