Problems and Error Messages
BASO-2 - 02.06 - V07 Page 6-3
Communication with an external device has been interrupted. Check that the
external devices are properly connected to the mains and to the coffee ma-
chine. If so, and the message still appears:
+ Contact After Sales Service!
Communication with an external device has been interrupted. Check that the
external devices are properly connected to the mains and to the coffee ma-
chine. If so, and the message still appears:
+ Contact After Sales Service!
The service door (panel) is not shut properly. Check it and if necessary, shut it.
+ Contact After Sales Service!
Product selection remains blocked until the milk panel is properly closed.
+ Contact After Sales Service!
Outlet is incorrectly placed (or is missing). If this message is still displayed after
verification:
+ Contact After Sales Service!
The internal control unit battery needs replacing.
+ Contact After Sales Service!
Serial EEPROM is defective.
+ Contact After Sales Service!
Switch off coffee machine, wait for 10-30 seconds and then switch back on. If
the problem persists, switch off the coffee machine.
+ Contact After Sales Service!
Switch off the coffee machine.
+ Contact After Sales Service!
6.1.2. Coffee products cannot be served
When the following messages are displayed on the lower display line, no tea or
coffee products can be served.
No products at all can be selected when this message is displayed.
Execute the cleaning program as described in chapter 5.3.
The right-hand coffee mill is out of coffee beans. Fill the bean container.
The left-hand coffee mill is out of coffee beans. Fill the bean container.
Empty grouts container and put it back in place.
Press [ ] key. If the problem persists, open the bean container hatch and re-
move the bean container. Remove the remaining coffee beans (e.g. using a
vacuum cleaner) and make sure that nothing (e.g. a piece of gravel) is stuck in
the mill. If not and the problem persists:
+ Contact After Sales Service!
selection locked
** LAN-Timeout **
selection locked
error account system
selection locked
door open
battery flat
** EEPROM error!
motor current
motor driver error
selection locked
empty container!
select product
grinder right empty
select product
grinder left blocked
select product
grinder right block.
selection locked
milk door open
selection locked
outlet missing
selection locked
clean machine
select product
grinder left empty
ª
To Next Page
Loading...
Need help?
General
