Cleaning
Cleaning Cappuccinatore CPT
BASO-2 - 01.05 - V07 Page 5-35
5.8.1 Daily cleaning of CPT (option)
Note:
After use, the cappuccinatore device must be cleaned as follows:
1. Read the following instructions before you con-
tinue cleaning.
Attention!
It is crucial that you read the measuring in-
structions and danger notices on the detergent
container’s label.
Danger!
Never mix the “weakly cleaning agent” with
another cleaning agent. Use only “weekly
cleaning agent” for the weekly cleaning.
Attention!
Fill water in the container first, then add the
cleaning agent.
2. Fill approx. 20 ml “weekly cleaning agent“ care-
fully in the container, filled with cold water.
3. Place the cappuccinatore’s suction tube (posi-
tion 3) in the cleaning container.
4. Open the valve via the CPT product button.
5. You can close the valve when there is only
steam coming out of the CPT (the valve closes
automatically after 60 seconds).
6. Empty and rinse the cleaning container with
clean water.
7. Place the cappuccinatore’s suction tube (posi-
tion 3) in the cleaning container, filled with
clean water.
8. Open the valve via the CPT product button.
9. You can close the valve when there is only
steam coming out of the CPT (the valve closes
automatically after 60 seconds).
5.8.2 Weekly cleaning of CPT (option)
1. Before you start, read point 1. of the “daily CPT cleaning”
2. After you have cleaned the cappuccinatore, pull it downwards and dismantle
it (position 4).
3. Fill approx. 20 ml “weekly cleaning agent“ carefully in the cleaning container,
filled with 1 liter of cold water.
4. Place the dismantled parts in the cleaning container overnight.
5. Finally clean the parts with a soft brush and rinse all parts thoroughly with
clean water.
6. Check whether the capppuccinatore’s packing rings (position 1) are still in-
tact.
7. Reassemble the cappuccinatore.
8. Mount the cappuccinatore to the machine.
Cappuccinatore
2
1
To Next Page
Loading...
Need help?
General
