Schiller BP-200 plus - Introduction; Overview

Page 13
Art. no.: 2.510701 rev.: c
Introduction 2
User Guide Overview 2.1
BP-200 plus
2Introduction
2.1 Overview
The BP-200 plus is a menu guided non-invasive blood pressure unit designed to
measure blood pressure in standalone mode and with a stress test system using an
ergometer or a treadmill. The BP-200 plus uses both auscultatory (Riva-Rocci,
Korotkoff) and oscillometric methods of measurement and can be used in cardiology,
internal medicine, sports medicine, rehabilitation, etc.
Measurements are initiated as follows:
• On demand from the stress system, typically CS-200, AT-10 plus, AT-110, etc. The
results are sent to the host system.
• Manually (defined by the user):
– At set intervals
– Single measurements
– Continuous mode that takes BP measurements continuously over a 15 minute
period.
When used with a stress test system, the BP-200 plus uses a QRS trigger signal to
reduce signal artefacts.
The unit is powered by an external low voltage medical grade dc power supply and
also has slots for four optional AA size batteries for backup.
The BP-200 plus is also available with an internal SpO2 and ECG module. This
enables the ECG amplifier to generate its own QRS trigger signal, and gives SpO2
measurement with peripheral pulse. SpO2 measurements cannot be uploaded to the
host system.