Page 75
Maintenance 7
User Guide Trouble Shooting 7.5
Art. no.: 0-48-0013 Rev. m
FRED easy
7.5.2 Transmission error Ethernet/Online FRED easy®
If the connection to the network fails, an error message is issued. Potential error mes-
sages include the following:
Error message Cause Remedy
• Error reading SD card Disconnect and reconnect the device to
confirm. If the message still appears, the de-
vice must be repaired.
• Technical problem Disconnect and reconnect the device to
confirm. If the message still appears, the de-
vice must be repaired.
• Incorrect network IP configura-
tion or DHCP server not availa-
ble
Verify the network configuration; if message
is still displayed, the device must be re-
paired.
• Ethernet adapter not inserted in
the Ethernet interface case
Turn device off and connect the Ethernet
adapter; if the message is still displayed, re-
place the Ethernet adapter. If the message
still appears, the device must be repaired.
• The pads are connected to the
device and are placed to the pa-
tient
Disconnect the pads from the device.
• Battery is empty Insert a new battery.
• Device not used for more than 3
minutes
Disconnect and reconnect the device to
confirm. If the message still appears, the de-
vice must be repaired.
• The device is not able to con-
nect to the server
Check the connection to the server and the
network configuration, then restart data
transmission; if the message is still dis-
played, the device must be repaired.
TRANSMISSION FAILURE
ERROR CODE : 001
SD CARD READING
TRANSMISSION FAILURE
ERROR CODE : 002
NOT ENOUGH MEMORY
TRANSMISSION FAILURE
ERROR CODE : 003
NETWORK CONFIGURATION
TRANSMISSION FAILURE
ERROR CODE : 004
ADAPTER DISCONNECTED
TRANSMISSION FAILURE
ERROR CODE : 005
PATIENT DETECTED
TRANSMISSION FAILURE
ERROR CODE : 006
BATTERY LEVEL
TRANSMISSION FAILURE
ERROR CODE : 007
TIME OUT INACTIVITY
TRANSMISSION FAILURE
ERROR CODE : 008
SESSION OPENING
To Next Page
Loading...
