Basic safety notes
14.00 | SRU-plus 20 - 60 | Assembly and Operating Manual | en | 389443 15
2.10 Malfunctions
Behavior in case of malfunctions
l
Immediately remove the product from operation and report
the malfunction to the responsible departments/persons.
l
Order appropriately trained personnel to rectify the
malfunction.
l
Do not recommission the product until the malfunction has
been rectified.
l
Test the product after a malfunction to establish whether it
still functions properly and no increased risks have arisen.
2.11 Disposal
Handling of disposal
The incorrect handling of disposal may impair the product's
safety and cause serious injuries as well as considerable material
and environmental harm.
l
Follow local regulations on dispatching product components
for recycling or proper disposal.
2.12 Fundamental dangers
General
l
Observe safety distances.
l
Never deactivate safety devices.
l
Before commissioning the product, take appropriate
protective measures to secure the danger zone.
l
Disconnect power sources before installation, modification,
maintenance, or calibration. Ensure that no residual energy
remains in the system.
l
If the energy supply is connected, do not move any parts by hand.
l
Do not reach into the open mechanism or movement area of
the product during operation.
2.12.1 Protection during handling and assembly
Incorrect handling and assembly
Incorrect handling and assembly may impair the product's safety
and cause serious injuries and considerable material damage.
l
Have all work carried out by appropriately qualified
personnel.
l
For all work, secure the product against accidental operation.
l
Observe the relevant accident prevention rules.
l
Use suitable assembly and transport equipment and take
precautions to prevent jamming and crushing.
To Next Page
Loading...
