Assembly
36 14.00 | SRU-plus 20 - 60 | Assembly and Operating Manual | en | 389443
5.4.1 Adjust swivel angle
CAUTION
Material damage due to incorrect settings!
By incorrect setting of the swivel angle parts can come loose and
the product may be damaged.
l
Only trained stuff may set the swivel angle.
l
Before setting the swivel angle release pressure.
Version with clamp
shell
1.
Loosen screw of the limiting sleeve (6) approx. one revolution.
2. Actuate air connection B (4).
3. Open exhaust throttle valve on air connection A (3) until the
pinion (5) starts to move.
ð Pinion swivels towards the end position.
4. Set the desired end position by twisting the stop B (2).
5. Check end position.
ð To do this, ventilate air connection B (4) and actuate it
again, if necessary adjust end position.
6. Tighten screw (6).
7. Loosen screw (7) approx. one revolution.
8.
Ventilate air connection B (4) and actuate air connection A (3).
9. Open exhaust throttle valve on air connection B (4) until the
pinion (5) starts to move.
ð Pinion swivels towards the end position.
10. Set the desired end position by twisting the stop A (1).
11. Check end position.
ð To do this, ventilate air connection A (3) and actuate it
again, if necessary adjust end position.
To Next Page
Loading...
