Maintenance
62 14.00 | SRU-plus 20 - 60 | Assembly and Operating Manual | en | 389443
8.5 Servicing shock absorber
8.5.1 Servicing shock absorbers (absorber variant -W)
1. Undo the screws (1).
2. Pull off the stop cover (2).
3. Remove the safety ring (4) from the piston.
4.
Pull out the piston rod (3) and remove the compression spring (5).
5. Pull out the piston (7) with the guide sleeve (6) and
dampening ring (8).
6. Replace dampening ring (8).
7. Insert the piston (7) with the guide sleeve (6) and dampening
ring (8) using the piston rod (3) as far as possible.
8. Check the shock absorber overlap (h),
}8.4.3 [/61].
ð If necessary, add or remove fitting disks on base side until
the required absorber overlap (h) is reached.
9. Remove the piston rod (3).
10. Grease and insert the compression spring (5).
11. Grease the piston rod (3) inside and outside and insert it.
12. Mount the safety ring (4).
ð Pay attention to the correct installation position of the
safety ring.
13. Mount the stop cover (2) with screws (1).
To Next Page
Loading...
