Maintenance
14.00 | SRU-plus 20 - 60 | Assembly and Operating Manual | en | 389443 63
8.5.2 Servicing shock absorbers (absorber variant -S)
1. Undo the screws (1).
2. Pull off the stop cover (2).
3. Remove the safety ring (4) from the piston.
4. Pull out the piston rod (3) and remove the absorber (5).
5. Use the M5 thread to pull out the cover (7) and dampening
ring (6).
6. Replace dampening ring (6).
7. Insert the cover (7) with the dampening ring (6) using the
piston rod (3) as far as possible.
8. Remove the piston rod (3).
9. Grease and insert the shock absorber (5).
10. Grease the piston rod (3) inside and outside and insert it.
11. Remount the safety ring (4).
ð Pay attention to the correct installation position of the
safety ring.
12. Mount the stop cover (2) with screws (1).
To Next Page
Loading...
