SCHUNK SRU-plus Series - Inspect and Set Shock Absorbers; Inspect Shock Absorbers; Set Shock Absorber Overhang

Maintenance
60 14.00 | SRU-plus 20 - 60 | Assembly and Operating Manual | en | 389443
8.4 Inspect and set shock absorbers
8.4.1 Inspect shock absorbers
The shock absorbers are specially tested and can only be acquired
from SCHUNK. The shock absorbers have a limited lifespan,
depending on the load.
l
Regulary check that the shock absorbers are working.
ð The shock absorber is working correctly if the product
moves softly into the end positions when set correctly and
the prescribed swiveling time is reached.
8.4.2 Set shock absorber overhang
For production reasons, shock absorbers may be of different
sizes. If a shock absorber is exchanged, the new shock absorber
with fitting disks must be set to the corresponding shock
absorber overhang (h).
1. First set the shock absorber overhang (h) of the shock
absorber (2) in the piston (1) with fitting disks
(5) }8.4.3 [/61].
2. After this, reduce the play of the shock absorber (2) to the
safety ring (3) with fitting disks (4).
ð The shock absorber (2) must be fitted in the pistons (1) as
free from play as possible.