SCHUNK SRU-plus Series - Page 37

Assembly
14.00 | SRU-plus 20 - 60 | Assembly and Operating Manual | en | 389443 37
12. Tighten screw (7).
ð Tightening torque:SRU-plus20-30: 1,2Nm
ð Tightening torque:SRU-plus 35-50: 2,1Nm
13. Swivel repeatedly to test the setting, adjust if necessary.
Version with limiting
sleeves
1. Loosen screw of the limiting sleeve (6) approx. one
revolution.
2. Actuate air connection B (4).
3. Open exhaust throttle valve on air connection A (3) until the
pinion (5) starts to move.
ð Pinion swivels towards the end position.
4. Set the desired end position by twisting the stop B (2).
5. Check end position.
ð To do this, ventilate air connection B (4) and actuate it
again, if necessary adjust end position.
6. Ventilate air connection B (4) and actuate air connection A
(3).
7. Open exhaust throttle valve on air connection B (4) until the
pinion (5) starts to move.
ð Pinion swivels towards the end position.
8. Set the desired end position by twisting the stop A (1).
9. Check end position.
ð To do this, ventilate air connection A (3) and actuate it
again, if necessary adjust end position.
10. Tighten screw (6).
ð Tightening torque: SRU-plus 20-40: 10Nm
ð Tightening torque: SRU-plus 50-60: 24Nm
11. Swivel repeatedly to test the setting, adjust if necessary.