Assembly
14.00 | SRU-plus 20 - 60 | Assembly and Operating Manual | en | 389443 41
NOTE
If the absorber stroke is changed, the swivel speed might also
need to be changed as well, so that the movement remains
smooth, }5.4.2 [/38].
ð IMPORTANT!If the stop pin is unscrewed too far, this
may cause the rotary actuator to leak.
By unscrewing stop pin A (4), the absorber stroke is
reduced.
ð By screwing in stop pin A (4), the absorber stroke is
increased.
5. Fix stop pin A (4) and tighten bolt (3).
6. Fix back stop A (2) and tighten bolt (3).
7. Swivel repeatedly to test the setting, set again if necessary.
ð The end positions must be approached gently.
8. Put on cover cap (4).
9. On the second shock absorber (6)
Repeat the steps for the other end position.
NOTE
Depending on the loading condition, the settings for the two
shock absorbers may deviate widely from each other.
To Next Page
Loading...
