SCHUNK WSG 50 - Overdrive Mode

Operation
04.00 | WSG 50 | Assembly and operating manual | en | 389474
63
7.14 Overdrive mode
The product is equipped with an overdrive mode, in which for
grasping cycles with short holding times (max. 2 seconds) and long
opening times (more than 10 seconds) grasping forces higher than
the nominal grasping force can be achieved. The overdrive mode
must be activated using a special command on the command
interface and will be displayed in the system state („Overdrive
Mode“).
Activating the overdrive mode will be noted in the system log Log
memory [
}
59].
NOTICE
Despite to thermal protecten, the product can be damaged when
overloading. For further information, please contact our technical
distributor.
NOTE
For a documentation of the overdrive mode, please check the
„WSG Command Set Reference Manual“.